HAMPTON BAY SFZ-500-1 Use And Care Manual page 9

Installation (continued)
□
Optional installing method is to replace the nail screws (FF) with
sleeve anchors (HH).
□
Place the mounting bracket (EE) at the desired postion on the
ceiling, mark the position through the holes of the mounting
bracket (EE), and then remove the mounting bracket (EE).
□
Drill the correct sized holes at the mark points, using an electric
screwdriver and clear the debris. Insert the sleeve anchors into
the drilled holes. Tap in place with a hammer if necessary.
□
from the sleeve anchors (HH). Place the mounting bracket through
the sleeve anchors (HH) and attach it to the ceiling by retightening
EE
Flat washer
Spring washer
Nut
□
the mounting bracket (EE) at the desired postion on the ceiling,
mark the position through the holes of the mounting bracket (EE),
and then remove the mounting bracket (EE).
□ Drill two holes at the mark points with depth 1/2 of the length of
the nail screws (FF), using an electric screwdriver. Clear the debris
and then drive the nail screws (FF) through the mounting bracket
(EE) and into the drilled holes. Tap in place with a hammer if
EE
5
□ Hold and support the bottom of the fan and lift it up close to the
□ Press the snap hook knob on the top of the hanger bracket
□ Slot the hook over the loop portion of the mounting bracket (EE)
□ Gently release the fan so that the fan does not wobble.
Concrete
ceiling
HH
Wooden
ceiling
FF
9
Hanging the Fan to the Mounting Bracket
mounting bracket (EE) on the ceiling.
assembly (A) to open the spring-loaded gate.
and let the knob go. The action of the spring will cause the hook
to snap closed, and securely make the connection.
Please contact 1-855-HD-HAMPTON for further assistance.
Ceiling
EE
A
Ceiling
EE
A
HAMPTONBAY.COM