Table of Contents
Advertisement
Installation (continued)
3
Positioning the Decorative Cap
□
Push down the decorative cap (B) to cover up the mounting
collar (C).
4
B
C
□
mounting bracket (EE) at the desired postion on the ceiling, mark
the position through the holes of the mounting bracket (EE), and
then remove the mounting bracket (EE).
□
Drill the correct sized holes at the mark points, using an electric
screwdriver and the nail screws (FF) and then pull the screws out.
Clear the debris and then insert the plastic anchors (GG) into the
drilled holes. Tap in with a hammer if necessary to ensure they are
□
Drive the nail screws (FF) through the mounting bracket (EE) and
into the plastic anchors (GG). Make sure the mounting bracket (EE)
8
Installing the Mounting Bracket to the
Ceiling
DANGER:
The proper method for installing the mounting
bracket must be chosen for different ceilings. Failure to do
so could allow the fan to wobble and/or fall. A falling fan
could cause serious personal injury or death.
WARNING:
Angle mounting is used for vaulted or angled
ceilings. If angle mounting is adopted for the fan, make sure
the ceiling angle is not steeper than 30 degrees and the
open end of the mounting bracket (not included) is up and
facing the ceiling.
NOTE: Remove all parts from the package, and verify that
everything listed in the Hardware Included section are
present.
Concrete
ceiling
GG
EE
FF
Advertisement
Table of Contents
