Installation - HAMPTON BAY SFZ-500-1 Use And Care Manual

Installation

1
Attaching Hanger Bracket Assembly
and Decorative Cap
WARNING:
to persons, turn off power to wall switch or make sure the
pull chain switch in off position before beginning installation.
WARNING: Ensure the hanging structure can support a
minimum weight of 65 lb and allow enough depth for safety
mounting. If you are not sure the hanging structure can
support the weight, do not attempt to install this fan as it
may fall and cause damage to the fan or personal injury.
WARNING: Make sure the ceiling angle is not steeper than
30 degrees and the open end of the mounting bracket (not
included) is up and facing the ceiling, if angle mounting is
adopted for the fan.
□ With the cupped side down, push up the decorative cap (B) to
top of the hanger bracket assembly (A) through the cap hole.
2
□ Pull out the hitch pin (AA) and then remove the clevis pin (BB)
□ Insert the hanger bracket assembly (A) into the mounting
□ Install the clevis pin (BB) througn the holes in the mounting
A
B
7
Attaching Fan Head to Hanger
Bracket Assembly
from the mounting collar (C) of fan head (D). Loosen the lock
screws (CC).
collar (C) and then rotate clockwise to make sure the hole at
the bottom of the hanger bracket assembly (A) aligns with
the hole in the mounting collar (C).
C
BB
collar (C) and the hanger bracket assembly (A) and then secure
it with the hitch pin (AA). Retighten the lock screws (CC).
C
AA
BB
Please contact 1-855-HD-HAMPTON for further assistance.
A
AA
CC
D
A
CC
HAMPTONBAY.COM