Subscribe to Our Youtube Channel
Related Manuals for REMKO CLK 80-RV
Summary of Contents for REMKO CLK 80-RV
- Page 1 REMKO CLK 80-RV CLK 170-RV Oil heaters Operation · Technology · Replacement parts Edition GB - D09...
-
Page 3: Table Of Contents
Troubleshooting Intended use Customer service and guarantee Environmental protection and recycling Exploded view of the unit Spare parts list Electrical wiring diagram CLK 80-RV Electrical wiring diagram CLK 170-RV Commissioning fan oil burner 20-21 Maintenance protocol Technical data Carefully read this operating manual prior to commissioning / using the unit! This operating manual is a translation of the German original. -
Page 4: Safety Notes
REMKO CLK 80/170-RV Safety notes Always observe the respective local building code and fire prevention guidelines as well as the guidelines of the accident prevention and insurance associations as a basic rule when using the unit. The units may only be operated... -
Page 5: Unit Description
REMKO Multiflex profile. oil pre-heating fitted as standard. With the CLK 80-RV this In simple ventilating mode the is available as an option unit can be used to recirculate the (EDP no. 1071411) . -
Page 6: Installation Instructions
REMKO CLK 80/170-RV installation instructions The safety regulations installation in closed, well Room heating ventilated areas without of the accident prevention and insurance associations, exhaust gas connection The units may only be operated ■ the respective regional building for room heating with a room... -
Page 7: Safety Device
Safety temperature limiter (STB) 1. Unscrew protective cap [1]. Only "REMKO original The unit is permanently switched replacement parts" must off by the safety temperature be used when replacing safety limiter (STB) in the event devices. -
Page 8: Exhaust Ducting
REMKO CLK 80/170-RV Exhaust ducting It is also possible to operate Fault-free operation All parts of the exhaust gas ■ ■ the units outside or in open is guaranteed if the exhaust routing must be reliably rooms / halls without exhaust gas gas routing is fitted in a rising fastened. -
Page 9: Before Commissioning
Before commissioning If the cycle intervals are too The units should be checked for Air distribution ■ short the length and layout visible defects on the operating The units are equipped with a high of the hot air routing should and safety devices as well performance radial fan, which be checked... -
Page 10: Commissioning
REMKO CLK 80/170-RV Commissioning Paraffin formation with low One person, who has been Control panel outside temperatures adequately trained in the handling of the unit, should be tasked with Even at low outside temperatures the operation and monitoring it is necessary to ensure that there of the unit. -
Page 11: Shutdown
Shutdown Heating with room thermostat Ventilate (Accessories) In this switch position the supply 1. Move the operating The units operate fully air fan runs permanently. switch to the "0" automatically and exclusively The units can be used for air (off) position. in accordance with the room recirculation or ventilation temperature. -
Page 12: Care And Maintenance
REMKO CLK 80/170-RV Care and maintenance Regular care and observation Check the fan blades and Cleaning the heat exchanger ■ of some basic points will ensure combustion chamber with heat trouble-free operation and a long exchanger for contamination 1. Set the operating switch service life. - Page 13 [2]. by authorised specialists 3. Loosen the 2 lower fastening Burner CLK 80-RV: X = 20 mm screws on the burner flange [6]. Burner CLK 170-RV: X = 30 mm 4. Loosen the clamping screw [7] on the burner flange 6 1.
-
Page 14: Troubleshooting
REMKO CLK 80/170-RV troubleshooting tensioning the V-belt 9. Move the operating switch AttEntiOn to the "II" (Ventilate) position. Before undertaking any work 1. Remove the two side air intake If the supply air fan now starts on the units, the power grills. -
Page 15: Intended Use
"certificate material, please consider our of their structural design and of guarantee" to REMKO gmbH & environment. equipment. Co. Kg at the time when the units Our units are carefully packed are purchased and commissioned. -
Page 16: Exploded View Of The Unit
REMKO Multiflex oil pre-heating, REMKO 2-strand oil filter, serial with CLK 170-RV with factory- Serial with CLK 80-RV with fitted oil burner. factory-fitted oil burner. We reserve the right to modify the dimensions and design as part of the ongoing technical development process. -
Page 17: Spare Parts List
Spare parts list Description CLK 80-RV CLK 170-RV Cover panel 1104740-1 1104851 Upper insulation 1104741-1 1104852 Insulation right / left 1104742 1104853 Upper side cover (right / left) 1104743 1104854 Lower side cover (right / left) 1104744-1 1104855 Lower insulation... -
Page 18: Electrical Wiring Diagram Clk 80-Rv
REMKO CLK 80/170-RV Electrical wiring diagram CLK 80-RV Legend: = Capacitor RT = Thermostat receptacle H1 = Operating lamp (green) S1 = Operating switch H2 = External burner fault lamp (red) S2 = Reset button - burner relay HR = Auxiliary relay... -
Page 19: Electrical Wiring Diagram Clk 170-Rv
Electrical wiring diagram CLK 170-RV Control circuit Legend: = Operating switch = Reset button (burner) Load circuit = Operating lamp (green) = External burner fault lamp (red) = Temperature controller = Temperature monitoring device = Safety temperature limiter = Terminal block = Fan motor = Burner connector, 7-pole = Thermostat receptacle... -
Page 20: Commissioning Fan Oil Burner
REMKO CLK 80/170-RV Commissioning the forced-air oil burner Preparatory tasks Adjusting the ignition electrode and baffle plate AttEntiOn The commissioning of the forced-air oil burner may only be carried out by trained specialists. After loosening the 4 fastening bolts the mounting baseplate M is pulled off the housing g. - Page 21 1. burner settings. 1. Remove the stopper on the measurement nozzle "P". CLK 80-RV Adjusting the air flap Turning to the left (–) 2. Fit a suitable oil pressure = smaller scale value Adjust the air flap as follows: manometer here.
-
Page 22: Maintenance Protocol
REMKO CLK 80/170-RV Maintenance protocol Unit type: ........Unit number: ........10 11 12 13 14 15 16 17 18 19 20 Unit cleaned - outside - Unit cleaned - inside - Fan blade cleaned Combustion chamber cleaned Heat exchanger cleaned... -
Page 23: Technical Data
CLK 80-RV CLK 170-RV Unit type nominal heating capacity Max. Nominal heat capacity Nominal flow rate 6,140 10,340 pressure (Max. total) Fuel Heating oil EL acc. to DIN 51603-1 or diesel fuel fuel consumption 15.5 Max. Danfoss oil nozzle 1.75 / 60°S... - Page 24 REMKO, a partner who helps to solve problems. Sales REMKO offers not just a well- established sales network both nationally and internationally, but also has exceptionally highly- qualified sales specialists. REMKO employees in the field...
Need help?
Do you have a question about the CLK 80-RV and is the answer not in the manual?
Questions and answers