Table of Contents
Advertisement
ELECTRIC OVEN
TELESCOPIC GLIDES
The telescopic glides fit any shelf level and work with the
wire shelves provided as standard equipment.
FITTING THE GLIDES
1) Locate the two spring clips at the front and back of the
glides.
2) Locate the pin on the glide that indicates the back.
3) Choose the right level and position the telescopic glide
near the upper wire.
4) Insert the rear spring clip on the glide.
5) Gently insert the front spring clip on the glide.
6) Pull and push each glide to ensure the correct
installation and smooth operation.
7) Extract both glides to the fully extended position and
place the shelf over them, making sure it is accurately
placed between the rear pin and the front pin.
REMOVING THE GLIDES
1) Locate the two spring clips at the front and back of the
glide.
2) Gently pull down the front spring clip.
3) Pull the glide away from the oven side - be careful not to
strain the clip.
4) Repeat steps 2 - 3 on rear spring clip to remove.
50
Fig. 47
Fig. 48
Fig. 49
Fig. 50
Advertisement
Table of Contents
Troubleshooting
