Step 2: Surface Burners; Step 3: Visual Checks - Bertazzoni MAS486GDFMXV Installation, User And Maintenance Manual

GAS CONVERSION

STEP 2: SURFACE BURNERS

To replace the nozzles of the surface burners, lift up the
burners and unscrew the nozzles shipped with the range
using a 7 mm (socket wrench).
Replace nozzles using the conversion set supplied with the
range or by a Bertazzoni authorized parts warehouse. Each
nozzle has a number indicating its flow diameter printed on
the body.
Consult the table number 1 and matching nozzles to
burners.

STEP 3: VISUAL CHECKS

SURFACE BURNERS
The burner flame color should be blue with no yellow on the
tips. It is not uncommon to see orange in the flame color;
this indicates the burning of airborne impurities in the gas
and will disappear with use. With propane (LP) gas, slight
yellow tips on the primary icon are normal.
The flame should burn completely around the burner cap. If
it does not, check that the cap is positioned correctly on the
base and that the ports are not blocked.
The flame should be stable with no excessive noise or
fluttering.
After performing all these visual checks, reinstall the
bottom panel of the oven compartment and proceed to
setting the minimum for each burner.
Fig. 34
Fig. 35
yellow flames: further adjustment is required
yellow tips on outer cones: normal for LP
gas
soft blue flames: normal for natural gas
29