Requirements And Prerequisites; Selecting The Installation Location; Required Tools; Mounting - Porsche Mobile Charger Owner's Manual

g Refer to chapter "Operating unit status indicators
and error messages" on page 16.
Requirements and prerequi-
sites

Selecting the installation location

Electric shock, fire
DANGER
Improper use of the charger or non-compliance with
the safety instructions can cause short circuits, elec-
tric shocks, explosions, fires or burns.
e
Do not install the Basic wall mount in potentially
explosive atmospheres.
e
To reduce the risk of explosion, particularly in
garages, make sure that the control unit is lo-
cated at least 19.7 in. (50 cm) above the floor
during charging.
e
Observe the locally applicable electrical installa-
tion regulations, fire protection measures, acci-
dent prevention regulations and escape routes.
The Basic wall mount is designed for indoor and out-
door installation.
The following criteria must be considered when se-
lecting a suitable installation location:
–
If possible, install the electrical socket and Basic
wall mount in a covered area away from direct
sunlight and rain (e.g.in a garage).
– Do not spray the Basic wall mount directly with
water (e.g. high-pressure cleaning equipment or
garden hoses).
–
Do not install the Basic wall mount under hang-
ing objects.
–
Do not install the Basic wall mount in stables,
livestock buildings or locations where ammonia
gases occur.
–
Install the Basic wall mount on a smooth surface.
–
In order to ensure secure fastening, check the
condition of the wall before installation.
–
Install the Basic wall mount so that it is not near
pathways and the charging cables do not cross
any pathways.
– Install the Basic wall mount so that the distance
from the power plug to the power socket does
not exceed the available supply cable length.
–
Install the electrical socket as close as possible
to the preferred parking position for the vehicle.
Take the orientation of the vehicle into account.
–
Make sure the distance of the electrical socket
from the floor and ceiling conforms to national
standards and regulations, to ensure comfortable
use.
g Refer to chapter "Safety instructions" on page 4.

Required tools

–
Level
–
Drill or hammer drill
–
Screwdriver

Requirements and prerequisites

Mounting

Installing the wall bracket

Mounting standard wall bracket (base)
Fig. 3: Drilling dimensions
1. Mark drill holes on the wall.
2. Drill fastening holes and insert anchors.
3. Press standard wall bracket 2 (Fig. 3) into cable
guide 1 (Fig. 3) from the front.
4. Screw standard wall bracket onto the wall.
Information
Install the wall bracket at a height of at least 1 m (3
ft.).
7