Requirements And Conditions Selecting The Installation Location; Tools Required; Installing; Installing The Wall Mount - Porsche 7PP.971.675.J Manual

Requirements and conditions
Selecting the installation location
Electric shock, fire
DANGER
Improper use of the charger or non-compliance with
the safety instructions may result in short circuits,
electric shocks, explosions, fire or burns.
e
Do not install the basic wall mount in potentially
explosive atmospheres.
e
To reduce the risk of explosion - particularly in
garages - make sure that the control unit is
located at least 50 cm above the floor during
charging.
e
Observe the locally applicable electrical installa-
tion regulations, fire protection measures, acci-
dent prevention regulations and escape routes.
The basic wall mount is designed for indoor and out-
door installation.
The following criteria must be considered when se-
lecting a suitable installation location:
– Install the electrical socket and basic wall mount
preferably in a covered area protected against
direct sunlight and rain (e.g. in a garage).
–
Do not spray the basic wall mount directly with
water (e.g. high-pressure cleaning equipment or
garden hoses)
–
Do not install the basic wall mount under sus-
pended or hanging objects.
–
Do not install the basic wall mount in stables,
livestock buildings or locations where ammonia
gases occur.
– Install the basic wall mount on a smooth surface.
– In order to ensure secure fastening, check the
condition of the wall before installing.
–
Install the basic wall mount so that it is not near
pathways and the charging cables do not cross
any pathways.
–
Install the basic wall mount so that the distance
between the plug and the socket does not ex-
ceed the length of the available supply cable.
– Install the electrical socket as close as possible
to the preferred vehicle parking position. Take
the orientation of the vehicle into account.
– The distance of the electrical socket from the
floor and ceiling should be selected in compli-
ance with national regulations and standards so
that comfortable use is ensured.
g Refer to chapter "Safety instructions" on page 33.

Tools required

–
Spirit level
–
Power or hammer drill
–
Screwdriver

Installing

Installing the wall mount

Installing the basic wall mount
Fig. 13 Drilling dimensions
1. Mark the drill holes on the wall.
2. Drill the mounting holes and insert wall plugs.
3. Press the basic wall mount (Fig. 13) into the
2
cable guide (Fig. 13) from the front.
1
4. Screw the basic wall mount onto the wall.
37