Table of Contents
Advertisement
Chapter 3 LED Display Control Setting
Module Size：Set the size of the module in a cabinet. The software determines
each module arrangement based on module size and cabinet size.
3） Adjust the coefficients (similar to the steps of coefficient adjustment in setting
coefficients for a new scan board). For details, refer to Step 2 and Step 3 in Section
3.5.1).
4） Save the correction coefficients to the hardware (Use similar steps in setting
coefficients for a new receiving card. For details, refer to Step 4, Step 5, and Step 6 in
Section 3.5.1) so that they are retentive after a power failure.
Fig 3-23 Obtaining Correction Coefficients for a New Module
38
Advertisement
Table of Contents
