Unilumin UHWII Series Product Manual page 46

Table of Contents

Advertisement

Chapter 3 LED Display Control Setting
5) Adjust Coefficient: Perform a simple adjustment if the displaying effect is not good
enough after you upload the coefficient. Then click Next.
Fig 3-19 Simple Adjustment
Red:Adjust the red brightness value of calibration coefficients.
Green:Adjust the green brightness value of calibration coefficients.
Blue:Adjust the blue brightness value of calibration coefficients.
6) Save Coefficients: Click Save to save the correction coefficients to the hardware.
The saved coefficients are retentive even after a power failure. Then click Finish.
Fig 3-20 Saving Correction Coefficients
36

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hwii1.2Uhwii1.5Uhwii1.9Uhwii2.5

Table of Contents