Table of Contents
Advertisement
2.2.3 Concave Installation（0° —2°）
1)
Make sure that the bottom beam is horizontal, and the value is within ± 1mm;
2)
Assemble the specific trimming cabinet from the bottom to the top and from the
middle to both sides successively;
3)
The left and right cabinets are fixed with left and right shoulder screw, and the
mounting plate and cabinets are fixed on the square pipe with hexagon socket
bolts;
4)
After the first line of cabinet is installed, the second line of cabinet is installed,
and the upper and lower cabinets are fixed with upper and lower shoulder screw;
5)
In the process of cabinet installation, it is necessary to pay attention to the gap
and flatness between cabinets.
Note:
1） The concave installation within 2 ° does not use angle block, but uses special trimming
cabinet for installation. During installation, pay attention to adjust the gap and flatness
between cabinets.
2） Rear installation recommended for Concave splicing.
Fig 2-15 Locking of left and right cabinets completed
Chapter 2 Installation and Wiring
Left/right shoulder screw
11
Advertisement
Table of Contents
