Table of Contents
Advertisement
7.
Installation procedure
7.1
Master camera installation & calibration
•
Verify the vehicle is parked on a flat surface (no slope)
•
The vehicle should be adjusted via the air suspension to a standard driving mode prior to
installation.
To calibrate the master camera, it is required first to use the Mobileye clone tool application (see
requirements
section #3
calibration process.
Note that the installation and calibration of the Master camera will be performed according to
the standard
Mobileye 6 installation procedure
MEgu2018@rL) with the additional steps as described below.
Please carefully follow the steps below:
1. Remove the relevant panels to mount all the components and route the cables.
2. Run all the cables in the front cabin towards the Junction Box location – Master harness,
Eyewatch and display cable/extension, CAN Sensor & E-Box (if connected).
3. Connect Power cable (BAT+, IGN and GND) to Junction Box.
4. Connect Signals (CAN or analog) and use the relevant harness - CAN-B cable (via CAN
Reader) or analog signals cable (Via AUX or E-box).
5. Connect the Eyewatch to the Junction Box and mount it in the designated place according to
the guidelines
described in this
6. Connect master camera to Junction Box.
7. Connect the laptop, open to clone tool application to burn the Master clone file profile.
Note:
Only one system can be connected to the JB when using the Clone tool / Mobileye setup wizard
8. Reset power to the junction box.
9. Open the Mobileye setup wizard to start with the calibration process of the Master camera.
Mobileye Shield+ V2.0| January 2022
Installation Manual v1.1
for further details) to burn the relevant clone tool profile prior to the
document.
Mobileye Proprietary and Confidential
support@mobileye.com
(User & password: aftermarketguest |
MOBILEYE, AN INTEL COMPANY
WWW.MOBILEYE.COM
Advertisement
Table of Contents
