Installation - Qubic System QS-S25 User Manual

QS-S25
3.

INSTALLATION

WARNING
Remember, even though possibilities with QS-S25 are broad, some things should be
kept in mind when the place for the rig is chosen. Motion Systems
exceeding or ignoring any of these points and
failures that are the results of these actions.
DO NOT use the QS-S25 on very soft or fragile surfaces like rubber, glass, or foam.
■
Ensure that all QS-S25 modules are mounted properly.
■
Be aware that QS-S25 will crawl a little in every direction during operation. Those
■
movements could damage the surface in the long term. Manufacturer, its sub-
sidiaries, and their partners are not responsible for any floor damages.
DO NOT mount the rig in tight or cluttered spaces – remember that QS-S25 moves
■
and nothing should restrict its motion range.
Seatbelts and other harnesses should be mounted to parts of the motion rig that
■
move in the same way as the seat.
Cables must not be stretched and should be kept in a way that prevents them from
■
getting under actuator or any part that can crush or tear them.
If you want to use the QS-S25 in an unusual application, and you are not sure, that
■
the desired setup is feasible, please contact, the distributor/reseller.
User Manual R2.0
Dangerous voltages level can be present in Power Cabinet
and cables during the operation and for a few minutes af-
ter turning off the machine.
DO NOT
IS NOT responsible for malfunctions or
attach them to any static part or ground.
DOES NOT approve
15