Group Outputs - Endress+Hauser PROline FieldCheck Operating Instructions Manual

PROline FieldCheck™
Endress+Hauser
9.5.2

Group OUTPUTS

Þ
BASIC FUNCTION G
Use this function group to view the configuration and settings of the current and frequency outputs
OUTPUT
(6900)
CURRENT SPAN
(6901)
VALUE 0_4 mA
(6902)
VALUE 20 mA
(6903)
TIME CONSTANT
(6904)
OPERATION MODE
(6905)
SENSOR DATA
ß
OUTPUTS
Function description
BASIC FUNCTION SENSOR DATA

Use this function to select the output
Options:
CURRENT OUTPUT
FREQUENCY OUTPUT
Factory setting:
CURRENT OUTPUT
Use this function to view the set current range in the measuring device.
!
Note!
This function is only available if the CURRENT OUTPUT option is selected in
the OUTPUT (6900) function.
Use this function to view the flow value, which is assigned to the 0_4 mA cur-
rent in the measuring device.
!
Note!
This function is only available if the CURRENT OUTPUT option is selected in
the OUTPUT (6900) function.
Use this function to view the flow value, which is assigned to the 20 mA cur-
rent in the measuring device.
!
Note!
This function is only available if the CURRENT OUTPUT option is selected in
the OUTPUT (6900) function.
Use this function to view the set damping of the current output in the measur-
ing device.
"
Caution!
If the set damping in the measuring device is greater than 5 seconds, you
will receive a warning message before the verification because this causes a
corruption of the result!
!
Note!
This function is only available if the CURRENT OUTPUT option is selected in
the OUTPUT (6900) function.
Use this function to view the set operating mode of the frequency output in
the measuring device.
!
Note!
This function is only available if FREQUENCY OUTPUT was selected in the
OUTPUT (6900) function.
GNA
GNB
9 Appendix
47