Group Communication - Endress+Hauser promag 50 PROFIBUS-PA Brief Operating Instructions

Promag 50 PROFIBUS-PA
Endress+Hauser
3.3

Group COMMUNICATION

Function description COMMUNICATION
TAG NAME Use this function to assign a tag name to the measuring device. You can edit
and read this tag name at the local display or by means of the PROFIBUS
protocol (class 2 master).
User input:
max. 16-character text, permissible: A-Z, 0-9, +,-, punctuation symbols
Factory setting:
"_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _" (without text)
BUS ADDRESS Use this function to define the address for the exchange of data with the aid of
the PROFIBUS-PA protocol.
User input:
0...126
Factory setting:
126
WRITE PROTECT This function shows the position of the jumper used to set general hardware
write protection.
Display:
OFF → write protection disabled
ON → write protection enabled; functions cannot be changed at the local
display or by means of the PROFIBUS protocol (class 2 master).
Factory setting:
OFF


A jumper on the I/O board provides the means of enabling or disabling write
protection (see the Operating Instructions promag 50, BA 055D/06/en/).
SELECTION GSD


In the configuration phase, each PROFIBUS device must check an ID number
allocated by the PNO. Along with this device-specific ID number there are also
PROFILE ID numbers that have to be accepted in the configuration phase as
well, for the purposes of interchangeability between devices of different make.
In this case the device might, under certain circumstances, reduce the func-
tionality for cyclic data to a scope defined in the profile.
Use this function to select the measuring device's configuration response.
Options:
MANUFACT.SPEC
PROFILE–GSD
Factory setting:
MANUFACT.SPEC
Note:
Note:
3 Operation
21