Response Of Outputs To Errors - Endress+Hauser Dosimag Operating Instructions Manual

Dosimag
!
"
Endress+Hauser
8.6

Response of outputs to errors

Note!
The failsafe mode of the pulse output and status output can be configured differently by means of
the ToF-Tool / FieldTool Package operating program. (→ Page 20)
Caution!
System or process errors defined as "Notice messages" have no effect whatsoever on the pulse
output. See the information on → Page 25 ff.
Actual value
No message Normal measured
value output
Notice message Fault is ignored,
i.e. normal
measured value
output on the
basis of ongoing
flow
measurement
Fault message Max. measured
value output
Normal measured
value output
1)
= In the event of error message (No. 359) "Pulse output frequency is out of range"
2)
= For all other errors
Pulse output
Failsafe mode
Fallback value Fault
message
Normal measured Conductive
value output
Fault is ignored, Conductive
i.e. normal
measured value
output on the
basis of ongoing
flow
measurement
No measured Not
1)
value output conductive
2)
Troubleshooting
Status output
Assign
Fault message Conductive
or notice conductive
message
Conductive Conductive
conductive
Not Conductive
conductive conductive
Not Conductive
conductive conductive
Not
Not
Not
Not
27