Table of Contents
Advertisement
Programming the timer
This VCR incorporates two programming procedures for timer recording.
One is conventional, and the TV programme No., start time, stop time, recording date, etc., must be input,
and the other is called "Video Plus+" and up to 9 digits must be input.
Programming the timer using "VideoPius+"
Things to know before starting programming
* To find the "PlusCode" number, look in the TV
* You have about one minute to complete each
section of most newspapers or TV guide
step of the procedure.
If you do not proceed to
magazines.
the next step within this time, all entries are
¢ Check that the time and date are correct.
erased and you must start again.
Controls
Remote Display
Be sure to check that "VCR1" or "VCR2" is
displayed.
This VCR is designed so it can be controlled when
either "VCR1" or "VCR2" is selected.
See "REMOTE CODE" on page 41.
BAS
OPE
2
Press the VIDEO PLUS+ button.
Enter the "PlusCode" number from the TV guide
or newspaper etc. for the programme you want
VCR1/2/TV
to record, by using the number buttons.
VIDEO PLUS+
ENTER
.
"
"
=
a
After entering the
"PlusCode"
number, press the
@-@®
1 Coay At =i MONTH
ENTER button.
ON
FF
o3a
t9:
The programmed details appear.
=
If you wish to change the programme allocations,
see the additional operations section for Video
Plus+ setup on page 42.
If you wish to change the start (ON) time or end
(OFF) time, press the TRACKING button W(for
start time) or A (for end time). The start (ON) time
can be brought forward by up to 10 minutes in
one minute intervals and the end (OFF) time can
be delayed by up to 60 minutes in 10 minutes
intervals.
Notes:
« Use of "PlusCode" numbers. "PlusCode"
numbers only record programmes at the times
shown in the TV guide.
The VCR timer wil! not follow the TV
programme if the time is changed for any
reason (e.g. delayed due to a previous
programme).
¢ When you press the ENTER button, "PDC" will
appear. Ignore these letters if you don't intend
to use this function or if your VCR does not
have this function.
If it is confusing, press the
PDC button to erase these letters.
27
Advertisement
Table of Contents
