Hitachi VIDEO plus+ VT-M430E(UK) Instruction Manual page 17

Only use video cassettes with the VHS) mark in
this VCR.
Insertion
Push the cassette through the door until the VCR
mechanism pulls it into the compartment.
The VCR automatically turns on and the indicator
turns on when the cassette is in place.
Press the EJECT button on the remote control
handset or the button D4 on the VCR.
The cassette will come partially out of the
compartment so you can pull it out.
¢ The indicator turns off when the cassette is
ejected.
* The cassette can be ejected with operate on or
off.
Remember that:
—The VCR automatically enters the play-back
mode when a cassette without its safety tab is
inserted.
—The VCR automatically ejects the cassette if the
REC or REC/IRT button is pressed when a
cassette without its safety tab is in the VCR.
—Be sure to check the safety tab before inserting
a cassette for the above reasons.
Type of video cassette
The table below shows the recording time of
different cassettes.
SPEED SELECT SWITCH
To avoid erasing a
recording
Break off the safety tab
using a screwdriver or
To re-record on a
cassette which has its ¢ Press the SP/LP button on the remote control
handset to select the recording speed before
recording. It is set to the correct speed
automatically during play, so it is not necessary
to change it over.
It is recommended to record in the SP mode for
higher quality picture and sound.
safety tab removed
Cover the hole with
cellophane tape.
17
SETT UP