Table of Contents
Advertisement
ee
ENDLESS PLAY [0] or [—]
Press @) to change the On-Screen Display
setting.
{O]:
Whenever you change the mode, the new
mode is automatically displayed on the TV
screen for a few seconds.
[—]:
Nothing will be displayed on the TV screen
even when you change the mode.
Notes:
¢ When the DISP. button is pressed, the on-
screen display will appear for a few seconds
whether the OSD is set to [O] or [—].
« When the DISP. button is pressed again before
the display disappears, the display will
disappear from the TV screen.
Press @) to change the Rental Play setting.
[O]:
The VCR will automatically start play-back
when a cassette with its safety tab removed
is inserted into the VCR.
Then the VCR will enter the rewind mode
when the tape reaches its end or when the
VCR plays a non-recorded section for
approximately 30 seconds.
After rewinding
the tape to its beginning, the VCR will eject
the cassette and turn off.
[—]: The rental play feature is switched off.
(However, the VCR will automatically start
play when a cassette with its safety tab
removed is inserted into the VCR.)
It is impossible to set both the RENTAL PLAY and
ENDLESS PLAY functions to [O] at the same time.
If you attempt to do so, the other function is
automatically set to [—].
When a cassette with its safety tab is loaded,
rental play does not operate even if this function
is set to [O].
Press @) to change the Endless Play setting.
[O0}:
You can play the tape from the beginning to
the end repeatedly.
While in the endless
play mode, you can perform still play, frame
advance, visual search, etc., however, this
does not mean the endless play feature is
switched off. To switch off the endless play
feature, you must select [—] with this
display.
{[—]: The endless play feature is switched off.
Advertisement
Table of Contents
