Hitachi VIDEO plus+ VT-M430E(UK) Instruction Manual page 48

Hide thumbs Also See for VIDEO plus+ VT-M430E(UK):
Table of Contents

Advertisement

Controls
TV Screen
Turn the satellite receiver on and select a satellite
programme other than programme number 12.
Turn the VCR on.
Point the handset at the front of VCR, then press
the MENU button, and @) button.
The satellite control set-up menu appears on the
TV screen.
pera ae etc ree ET
ea Je
Press the @) button to select "L2".
The satellite picture should now appear on the TV
screen.
MENU
Press the ENTER button.
If this type number is incorrect for your satellite
receiver, refer to table opposite.
Enter the code
using the number buttons on the remote control
handset.
After entering the numbers, the VCR will
transmit a control signal to the satellite receiver.
Press the stop [] button.
If the programme number of the satellite receiver
changes to "12", your satellite receiver can be
controlled by this VCR.
Press the MENU button
to end programming.
If the programme number
does not change to "12", follow the next
procedure.
Brand
Number
HITACHI
AMSTRAD
ae
oe
CAMBRIDGE [ 13 |
a a ae ee
| 16 |
oe
ae
a
MASPRO
PHILIPS
TECHNISAT
FERGUSON
UNIDON
Press and release the play [> button.
If the satellite receiver programme number still
does not change to "12", press the [> button
again.
Repeat this step until the programme
number changes to "12".
lf your satellite receiver does not work after
entering the code shown, please try an alternative
code from table.
Note:
With some satellite receivers, the
programme number may not change to "12" even
if the code is correct.
Read the instruction manual
of your satellite receiver carefully and set up the
receiver correctly, then perform the above
operation.
After programming the system control code, press
the MENU button to return to normal operating
mode.

Advertisement

Table of Contents
loading

Table of Contents