Programming The Timer - Hitachi VT-FX950EUKN Instruction Manual

(TIMER RECORDING)

Programming the timer

This VCR incorporates two programming procedures for timer recording.
One is conventional, whereby the TV programme No., start time, stop time, recording date, etc., must be input,
and the other is called VIDEO Plus+ whereby up to 9 digits must be input.
Programming the timer using VIDEO Plus+ programming system
Things to know before starting programming
• Turn the VCR and TV on, then set the TV to the
video programme number.
• While you are programming the timer, the display
on the TV screen will prompt you through the
procedure.
Controls
1
2
1 2 3
VIDEO Plus+
4 5 6
7 8 9
0
0000
3
4
30
TV Screen
V I DEO PLUS PROGRAMME
ENTER THE P LUSCODE
–
+ =MANUAL
VIDEOPLUS
=
MENU
~
0 9
V I DEO PLUS PROGRAMME
ENTER THE P LUSCODE
123
+ =
VIDEOPLUS
OK
=
0 0 0 0 MENU
T I MER RO P G
CH0 2
19 : 30 20 : 00
17 / 05 / 00 WE
DAY/MONTH/YEAR
7 =DLY/WKL
0 0 0 0 = MENU =
cursor
T I MER RO P G
CH 0 2
19 : 30 20 : 00
17 / 05 / 00 WE
DAY/MONTH/YEAR
0 0 0 0 = MENU =
• To find the PlusCode number, look in the TV
section of most newspapers or TV guide
magazines.
• Check that the time and date are correct.
Turn the VCR and TV on, then set the TV to the
video programme number.
Press the VIDEO Plus+ button.
The VIDEO PLUS PROGRAMME display appears on
the TV screen.
Notes:
• If the clock has not been set, the CLOCK SET
display will appear.
Exit
• If the VIDEO Plus+ button is pressed when all the
programme numbers that the VCR can store are
occupied, a "FULL" indication will appear in the
VCR's display and on the TV screen.
When the memory is full, and you wish to input
further programmes, you must delete unwanted
programmes from the VCR's memory.
Press the button when the programme
0
information you want to clear is displayed. Refer to
page 36 for further information.
FULL
Enter the PlusCode programming number from the
TV guide or newspaper etc. for the programme you
want to record, by using the number buttons.
Exit
=
After entering the PlusCode number, press the
VIDEO Plus+ button.
The programmed details appear.
Note: If you have entered a non-existing number,
SP
"ERROR" will appear on the TV screen.
Exit
E OR RR
If you wish to change the programme allocations, the
start time or end time, press the 0000 button to
display the cursor " ". Press the 0000 button
SP
repeatedly until the cursor reaches the digit you want
Exit
to change, then enter the programme number, start
time or end time.