Table of Contents
Advertisement
TIMER RECORDING
The programmable
electronic clock/timer permits the unattended recording of up to 8 preselected pro-
rams, including one program on the same day of each week or one program at the same time every day.
1. Insert the Cassette.
2. Press the SPEED button to select "SP"
or
"EP'.
3. Set the program timer.
"START
(ON) TIME",
"STOP (OFF) TIME",
"DAY"
etc. See below.
4. Turn power off.
Now recording will begin
automatically at the start time.
Notes:
•
It is not necessary to press RECORD button.
•
The TIMER indicator flashes to warn that
recording will not occur because cassette has
not been inserted. If the safety tab on the cas-
sette has been removed, the VCR will auto-
matically eject the cassette when placed in the
Timer mode.
•
Programming
the timer for unattended
recording
For unattended recording the timer needs to know what day to make the recording, the time to start,
the time to stop, and the channel to be recorded.
Things to know before starting
• While you are programming the timer, the
"menu"
display on the TV
screen will
prompt you through the procedures.
•
You can correct an error in the program
any time before the last step by pressing
CLEAR button repeatedly until the digit to
be corrected becomes flashing and .then
enter the correct digit.
•
The programming ,will automatically re-
sume the "original
menu" if no further
steps are followed in programming for
about 1 minute.
1. Turn on the power of both VCR and TV.
2. Be sure that the TV is set to the video chan-
nel (channel 3 or 4).
(See page 16.)
3. Aim the remote control unit at the receiver on
the front panel of the VCR.
POWER button-
GUIDE button_
CLEAR button /
OOO_C
•
-Number
buttons
"0" through
"9"
-TAPE
SPEED
button
E29
Advertisement
Table of Contents
