Table of Contents
Advertisement
Chassis
Clean the vehicle thoroughly, removing
all dirt and grease accumulation.
~CAUTION
: Plastic alloy com po-
T
nents such as fuel tank, wind-
shield, controls, etc., can be cleaned
using mild detergents or isopropyl al-
cohol and a soft clean cloth. Never
clean plastic parts with strong deter-
gent, degreasing agent, paint thinner,
acetone, etc. Do not apply isopropyl
alcohol directly on decals.
Inspect the hood and see an authorized
dealer to repair any damage. Clean the
frame.
Touch up all metal spots where paint
has been scratched off. Spray all bare
metal parts with metal protector. Wax
the hood and the painted portion of the
frame for better protection.
0
NOTE : Apply wax on glossy fin-
ish only. Protect the vehicle with
a cover to prevent dust accumulation
during storage.
~CAUTION
: If for some reason
T
the snowmobile has to be stored
outside it is necessary to cover it with
an opaque tarpaulin. This caution will
prevent the sun rays and the grime
from affecting the plastic components
and the vehicle finish.
General Inspection
Check the electrical wiring and com-
ponents, retighten loose connections.
Check for stripped wires or damaged in-
sulation.
Thoroughly inspect the vehicle and tight-
en loose bolts, nuts and linkage.
0
NOTE : Leave the drive belt off
the pulleys for the entire storage
period.
Suspension Stopper Strap
Replace annually and
I
or as stopper
strap condition dictates. Torque nut to :
Citation
IE:
7 N•m (62 lbf•in)
Tundra, Tundra LT: 9 N•m (80 lbf•in).
39
Advertisement
Table of Contents
