Table of Contents
Advertisement
If adjustment is required :
Loosen the lock nuts of the longest tie
rod. Turn the tie rod manually until the
skis are properly aligned. Firmly retight-
en the lock nuts.
A003 003 001
Longest
----Jill..
tie rod
I
3
mm (1/8 in)
1
I
I
The handlebar should also be horizon-
tal when the skis are pointed toward the
front.
To adjust:
Loosen the lock nuts of the shortest tie
rod. Turn the tie rod manually until the
handlebar is horizontal. Retighten the
lock nuts firmly.
A
WARNING: The maximum ball
T
joint external threaded length
not engaged in the tie rod end must
not exceed 28 mm (1-7 /64 in). Torque
lock nut to 20 N•m (15 lbf•ft).
32
(TYPICAL)
28
mm
(1-7/64 in)
maximum
Torque to
20 N•m (15 lbf•ft)
A002 006 008
A
WARNING : The ball joint socket
T
must run parallel with the steer-
ing arm. The tie rod must be restrained
when tightening the tie rod end lock
nuts.
Restrain
Tighten
~
A007 006 004
A007 006 003
Muffler Attachment
The engine
I
exhaust system parts are
vital toward efficient muffler function.
Check all attachments and muffler ball
joint. Replace the springs and
I
or tight-
en if necessary .
...,. CAUTION : Do not operate vehi-
T
cle with muffler disconnected
otherwise serious engine damage will
occur.
Engine Mount Nuts
Check the engine mount nuts for tight-
ness. Retorque
if
required to 55 N•m
(41 lbf•ft).
Advertisement
Table of Contents
