Table of Contents
Advertisement
Belt Guard Removal
A
WARNING : Belt guard should ai-
T
ways be in place when engine is
running.
A.
Raise the hood and pull both retain-
ing pins out.
B. Remove the guard.
Belt guard
Pin
A003 004 013
Drive Belt Removal
and Installation
A
WARNING : Never start or run
T
engine without the drive belt in-
stalled. Running an unloaded engine
is dangerous.
1. Tilt the hood and remove the belt
guard.
2. Unlock and raise driven pulley sup-
port.
1° Pull hair pin
3° Raise diven
pully support
ft/
A003 003 004
24
3. Open the driven pulley by twisting
and pushing the sliding half. Hold in
fully open position.
1° Twist clockwise
2° Push
Driven
pulley
4. Slip the belt over the top edge of the
sliding half.
A003 003 022
Advertisement
Table of Contents
