Table of Contents
Advertisement
Drive Pulley
Inspection and cleaning must be per-
formed by an authorized dealer at the
end of each season.
Engine
Engine internal parts must be lubricated
to protect them from possible rust for-
mation during the storage period.
To perform the storage procedures pro-
ceed as follows :
1. Lift the rear of the vehicle and sup-
port it off the ground .
•
WARNING : Ensure the track is
T
free of all particles which could
be thrown out while it is rotating. Keep
hands, tools, feet and clothing clear
of track. Ensure no one is standing in
close proximity to the vehicle.
2. Start the engine and allow it to run at
idle speed until the engine reaches
its operational temperature.
3. Stop the engine.
4. To prevent fuel from draining, primer
button should be pushed all the way.
5. Disconnect the outlet primer hose
from the primer valve.
A017 002 014
(Oblique
coupling)
Outlet~
hose
(Straight
coupling)
6. Insert storage oil (PIN 496 0141 00)
can hose into primer outlet hose.
7. Restart engine and run at idle.
8. Inject storage oil until the· engine
dies or until a sufficient quantity of
oil has entered the engine (approxi-
mately 30 seconds).
9. With the engine stopped, remove the
spark plug and pour approximately,
85 ml (3 imp. oz) of Bombardier oil
into cylinder.
10. Crank slowly two or three revolutions
to lubricate cylinder.
11. Reinstall the spark plug and the out-
let primer hose.
Do not run engine during storage pe-
riod.
Driven Pulley
Remove pulley guard and slip off drive
belt. Open the driven pulley, (push and
twist sliding half).
Thoroughly clean the driven pulley shaft.
Apply a light film of low-temperature
grease on the shaft. Always wipe off
surplus.
0
NOTE : Activate the sliding half
several times to distribute lubricant
over full length of shaft. Be careful that
lubricant does not get on inner halves
of pulley.
Brake Caliper
See your authorized dealer .
•
WARNING: Do not lubricate
T
throttle and
I
or brake cables and
housings.
37
Advertisement
Table of Contents
