Table of Contents
Advertisement
Tighten lock nuts and recheck the align-
ment.
Retighten
A001 005 003
Drive Pulley
.A.
WARNING: The drive pulley
T
must be inspected and cleaned
by an authorized dealer at least an-
nually.
Citation IE
Designed with maintenance-free bush-
ings.
Tundra, Tundra L T
Inspect the Duralon bushing
con~it~on
by checking the free-play of the
slldt~g
half pulley. This is achieved bX
res~ram
ing the inner half and check1ng
1f
the
sliding half moves in the direction of
the arrows more than 3 mm
(1/8
in). If
so, contact the dealer. No lubrication is
required.
A007 003 004
Steering Mechanism
Inspect the steering mechan.ism for tigh.t-
ness of components (steenng arms, t1e
rods, ball joints, spring
couple~
bolts,
etc.}. If necessary, replace or ret1ghten.
Torque steering arm bolts making sure to
keep a minimum gap of 5 mm (13/64 in)
between lugs.
5 mm (13/64 in)
min.
A003 006 001
50 N•m (37 lbf•ftl
.A.
WARNING : Check the condition
T
of the skis, ski runners and leaf
spring. Replace if more than half
worn.
Steering Adjustment
Skis should have a toe out of 3 mm
(1/8
in). To check, measure the distance
between each ski at the front and rear
of the leaf spring. The front distance
should be 3 mm
(1/8
in) more than the
rear when the handlebar is horizontal.
IMPORTANT : Close the front of the
skis to eliminate all slack from the steer-
ing mechanism using a rubber strap.
31
Advertisement
Table of Contents
