Table of Contents
Advertisement
+
WARNING: Brake pads must be
replaced as soon as only 1 mm
(1/32 in) of the fixed pad is still project-
ed out of caliper. Replacement must
be performed by an authorized dealer.
Minimum projection
of fixed pad : 1 mm (1/32 in)
A008 003 015
Brake Adjustment
The brake mechanism is a self-adjusting
type. If a quicker brake response is de-
sired, strongly squeeze the brake lever
several times/ this will actuate the self
adjusting mechanism.
AOOS 006 002
After the adjustment, brake should ap-
ply fully when lever is approximatively
13 mm (1/2 in) from handlebar grip. If
not, do not tamper with the brake, con-
tact your authorized dealer.
26 ---------------------------
A008 006 002
Brake Light Switch
Adjustment
To check operation :
Pull the brake lever to hold the pads on
the disc. Check that a light resistance
is felt while rotating the driven pulley.
This is the position where the switch
should have turned the brake light on.
To adjust:
- Loosen the brake switch lock nut
while restraining the other one.
- By turning adjusting nut, pull the
switch outward to turn the light on
or push inward to turn it off.
Lock nut
A003 003 024
Adjusting nut
Pull outward
to turn on
- Tighten the lock nut while restraining
the other one. Recheck brake light
operation.
Advertisement
Table of Contents
