Hard Drive Indicator Codes - Dell DR4300 System Owner's Manual

Expansion card installation guidelines

Hard drive indicator codes

Each hard drive carrier has an activity indicator and a status indicator. The indicators provide information about the current status of the
hard drive. The activity LED indicates whether hard drive is currently in use or not. The status LED indicates the power condition of the
hard drive.
Figure 3. Hard drive indicators
1. hard drive activity indicator
2. hard drive status indicator
3. hard drive
NOTE: If the hard drive is in the Advanced Host Controller Interface (AHCI) mode, the status indicator (on the right
side) does not turn on.
Table 4. Hard drive indicator codes
Drive-status indicator pattern (RAID only)
Flashes green twice per second
Off
Flashes green, amber, and then turns off
Flashes amber four times per second
Flashes green slowly
Steady green
Flashes green for three seconds, amber for three seconds, and
then turns off after six seconds
12 Dell DR4300 system overview
Condition
Identifying drive or preparing for removal.
Drive ready for insertion or removal.
NOTE: The drive status indicator remains off until all hard
drives are initialized after the system is turned on. Drives are
not ready for insertion or removal during this time.
Predicted drive failure
Drive failed
Drive rebuilding
Drive online
Rebuild stopped