Installation; Basic Configuration; System Tab; Status Tab - peplink PEPWAVE Balance One User Manual

10

Installation

The following section details connecting the Peplink Balance to your network:
10.1
Preparation
Before installing your Peplink Balance, please prepare the following:
● At least one Internet/WAN access account
● For each network connection, one 10/100BaseT UTP cable with RJ45 connector, one
1000BaseT Cat5E UTP cable for the Gigabit port, or one USB modem for the USB WAN
port
● A computer with the TCP/IP network protocol and a web browser installed— Supported
browsers include Microsoft Internet Explorer 11 or above, Mozilla Firefox 24 or above,
Apple Safari 7 or above, and Google Chrome 18 or above.
10.2
Constructing the Network
At the high level, construct the network according to the following steps:
1. With an Ethernet cable, connect a computer to one of the LAN ports on the Peplink
Balance. For Peplink Balance models that support multiple connections, repeat with
different cables connect up to 4 computers.
2. With another Ethernet cable, connect the WAN/broadband modem to one of the WAN ports
on the Peplink Balance. Repeat using different cables to connect from two to 13
WAN/broadband connections or connect a USB modem to the USB WAN port.
3. Connect the provided power adapter or cord to the power connector on the Peplink
Balance, and then plug the power adapter into a power outlet.
11 Basic Configuration
Please refer to this
how to configure using the Setup Wizard.
12 Network Tab
Please refer to this
13

System Tab

Please refer to this
14

Status Tab

Please refer to this
https://www.peplink.com
link for more information on how to connect to the Web Admin interface and
link .
link .
link .
73 Copyright @ 2022 Peplink