Siemens SIMOTION Operating Instructions Manual page 161

Meaning
Request for overall reset by the SIMOTION C or
via the mode selector of the SIMOTION C
Overall reset in progress
Overall reset completed
SIMOTION Kernel update in progress
(only for SIMOTION C230-2)
SIMOTION Kernel update completed
(only for SIMOTION C230-2)
SIMOTION C240 without micro memory card
Copy SIMOTION Kernel to micro memory card
SIMOTION C is operating without error
An event that can be acknowledged (alarm, mes‐
sage, note) is present
Fault to which the user program cannot respond
The following actions may be required to rectify
the fault:
● Switch Off/On
● Check micro memory card
● Re-commissioning
● Replacement of SIMOTION C
No license exists for technology/option objects
which require a license
SIMOTION - STOP state
User program is running at a breakpoint
PROFIBUS DP interface as slave
Bus fault
Searching for baud rate
Parameterization error
No cyclic data exchange
Cyclic data exchange
PROFIBUS DP interface as master
Bus fault (bus short-circuit)
Bus fault (slaves have failed or cable break)
No error or no interface configured
SIMOTION C
Operating Instructions, 11/2016, A5E33441428B
LED displays
SF 5 VDC RUN
(red) (green) (green)
x 1 0
1 1 1
x 1 0
→ 1 →
x 1 0
1 1 0
0.5/1 1 0.5/1
0 1 x
1 1 x
x 1 x
0.5/1 1 x
x 1 0.5/1
x 1 x
x 1 x
x 1 x
x 1 x
x 1 x
x 1 x
Alarm, error, and system messages
10.2 Combinations of LED displays
STOPU STOP BUS1F
(yellow) (yellow)
0 0.5/1 x
1 1 1
0 1 x
→ → →
0 1 x
1 1 1
0.5/1 0.5/1 0.5/1
x x 0
x x x
☆ ☆ ☆
x x x
1 1 x
x x 1
x x 0.5/1
x x 0
x x 1
x x 0.5/1
x x 0
BUS2F
(red) (red)
x
1
x
→
x
1
0.5/1
0
x
☆
x
x
1
0.5/1
0
1
0.5/1
0
161