Siemens SIMOTION Operating Instructions Manual page 103

Procedure:
1. Wire the free cable end of the connecting cable to the terminals on the drive unit. (The
terminal markings on the cable ends indicate the corresponding terminals for SIMODRIVE
devices.)
2. Open the front cover of the C230-2/C240 and connect the Sub-D socket (50-pin) to the X2
connector.
3. Lock the connector using the finger screws. Close the front cover.
Connecting cable
The connecting cable is a pre-assembled cable for four axes with an analog interface and
terminal designation for SIMODRIVE drive units.
The connecting cable is available in a choice of lengths.
See
Wiring diagram
Figure 6-9
Setpoint assignment
SIMOTION C
Operating Instructions, 11/2016, A5E33441428B
Catalog PM 21, NC 60, or ST 70
Terminal diagram for C230-2/C240 and SIMODRIVE 611 universal with analog setpoint
interface
Connecting
6.1 Wiring
103