Siemens SIMOTION Operating Instructions Manual page 76

Interfaces
4.8 I/O interface
The following table describes the states of the enables and outputs in the respective
SIMOTION C operating states with an open or closed READY contact.
Table 4-19
Status of the READY
Open
Closed
Additional references
You can find information about TO outputCam and TO measuringInput in the
Output Cams and Measuring Inputs Function Manual.
76
States of enable signals and outputs:
SIMOTION C
contact
● During ramp-up
● During memory reset
● With fault condition
● In STOP state
● In STOPU state
● in RUN state
Status of enable signals and outputs:
● Controller enable deactivated
● Analog outputs at 0 V
● Digital outputs deactivated
Enable signals and outputs controlled by user pro‐
gram and technology
Operating Instructions, 11/2016, A5E33441428B
SIMOTION
SIMOTION C