Electrical Connection - Environmental Water Systems EWS-SPECTRUM Product And Installation Manual

Whole home water filtration systems
Table of Contents

Advertisement

installation Instructions - all systems - electrical connections
INSTALL eLeCTRICAL CONNeCTION
10.
Connect electrical power by plugging the transformer into a standard grounded and
unswitched 110/115/120v electrical outlet.
If outlet is over 9 feet away use 18 gauge extension cord to connect up to 100 feet away.
Do not exceed 100 feet. Do not cut or splice original equipment.
If you haven't already done so from Page 9, 5c. Plug outlet from transformer into the
input on the valve. The input is in a protected area to avoid any damage from water.
See input location on the valve on Page 9
NOTe: POWeR CONSUMPTION
CAUTION:
touch screen home page and what you see when the system is on
When system is plugged in the screen will light up and both the upper right and left boxes will be blinking.
NOTE:
NOTE:
wed
12:01 am
Home Page
once the system
is plugged in this
is the 1st screen
you will see
If the home's plumbing system is copper (or any metal) then it may be necessary to install a jumper.
Install a jumper between the incoming and outgoing pipes before and after the flexible stainless
connections to maintain the continuity of the systems' ground. Properly ground system to conform
with all codes and ordinances.
Do not worry this is normal and they will stop blinking once the time is set (left) and the system
is run through the start up (right).
Similar to any smart phone you must be directly in front of the screen to see.
Taller units may require a step ladder to see the screen properly.
Press and hold the screen briefly so the screen reads your touch properly.
Just like a new smart phone, it may take a moment to adjust to the screen.
Water Treatment
treatment
ok, lets, set the clock
Power consumption is that of a radio alarm clock or a doorbell.
custom
11 h
59 m
NoTe:
day & Time are the only
changes needed.
system does not need any
additional programming.
Please follow the instructions
and allow system to run through
the pre-programmed start-up
and flush.
12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents