Table of Contents
Advertisement
4.5.2) Simultaneous extraction of 2 E clips
Make sure the locking knob (27) of the wheel is released (see § 4.2).
– Make sure the teeth (33) of the clamps are moved fully forwarded by pulling the control
lever to the right in "INSERT" position.
– Completely lower the machine, positioning the yellow locator plates (36) near the
E clip retention plates (see Fig. 12a).
FIG. 12a
– Pull the control lever (07) to the left in "EXTRACT" position: to gradually move the teeth
forwards with consequent extraction of both E clips (see Fig. 12b and 12c).
When performing the extraction operation, each clamps teeth (33) will move in opposite
directions.
FIG. 12b
NOTE: During clips extraction, the movement of the teeth may NOT be simultaneous because the
two clamps operate independently.
FIG. 12c
33
36
(Ref. to Fig.12)
E clip
retention plate
33
33
16
Advertisement
Table of Contents
