Table of Contents
Advertisement
4.1.2) Disassembly of the machine
To disassemble the machine:
– First lower the rear part and lock with pin (27),
block wheel (30) then reverse the process de-
scribed in § 4.1.
– Before disconnecting the pump unit, make sure
to have disconnected the hydraulic circuit and
the braking device; locate the hoses in support
(S) got on the frame of the pump unit.
If necessary, with the machine fully assembled and
the motor switched off, the clamps can always be
opened or closed manually.
NOTE: Under normal conditions, the time taken to
remove the machine from the rail is approximately
60 seconds.
4.2) Moving the machine
To move the machine along the track, the rear part must be raised to prevent the clamps knock-
ing against the E clip. To do this, simply:
1 -
Pull and turn knob (27). The wheel arm will be freed.
2 -
Slightly raise the machine by means of handlebar
(08); lifting will be made easier by the two gas
springs, then release the knob (27) to lock the
machine fully up.
3
- Press brake release handle (45) against the
handlebar (08).
4
- Push the machine along the rail.
27
1
FIG. 4b – MOVING THE MACHINE
(Ref. to Fig. 4 and 4a)
FIG. 4a – SUPPORT
(Ref. to Fig. 4b)
2
S
45
3
08
4
10
Advertisement
Table of Contents
