Grease Points - Wallenstein WX900 Series Operator's Manual

Service and Maintenance

9.4 Grease Points

IMPORTANT! Do not over grease a bearing. Too much
grease can cause the bearing seals to fail.
Look for this type of label on the machine. Each
label identifies a grease point and shows the
greasing interval in hours.
For grease specifications, see Grease on page 57.
• Use a clean cloth to clean each grease fitting before you
apply grease. This prevents grease and dirt from getting
inside the component.
• Use a hand-held grease gun to apply one pump of grease
to each grease point.
• If a grease fitting is damaged, replace it immediately.
• If a grease fitting does not accept grease:
a. Remove the grease fitting.
b. Clean the passageway behind the grease fitting.
c. Clean the grease fitting thoroughly or get a new grease
fitting.
d. Install the grease fitting.
36
WX900 Series
Log Splitter