Table of Contents
Advertisement
Quick Links
www.ti.com
User's Guide
TIOx1x2x Evaluation Module
This user guide describes the features and operation of the TIOx1x2xEVM Evaluation Module. It can be used
as a reference to help designers through the device performance evaluation process, and also promotes
fast product development. The TIOx1x2xEVM can be configured to support all devices in the TIOL11xx and
TIOS10xx product families and comes with both a TIOL1123 and TIOS1023 device installed by default. The
EVM contains an industry standard 4-pin M12 connector in a Class A 2-channel configuration with one IO-Link
communication channel and one digital output (DO) channel. The low-voltage digital input and output signals
are easily accessible for connection to a microcontroller and test equipment through both header pins and test
points. The board can also be directly connected to a number of TI microcontroller boards.
1
Introduction.............................................................................................................................................................................2
1.1 Features.............................................................................................................................................................................
1.2 Description.........................................................................................................................................................................
2.1 Evaluation Equipment........................................................................................................................................................
2.2 Power Overview.................................................................................................................................................................
Overview.......................................................................................................................................................3
(NFAULT)..................................................................................................................................................4
2.5 Transient Protection and Custom Loads............................................................................................................................
2.7 Digital Sensor Output Driver Control (TIOS102x and TIOS112x)......................................................................................
2.8 EVM Jumper Settings........................................................................................................................................................
Materials.............................................................................................................................................5
3.1 Schematic..........................................................................................................................................................................
Materials...................................................................................................................................................................7
History......................................................................................................................................................................9
Trademarks
All trademarks are the property of their respective owners.
SLLU344 - FEBRUARY 2022
Submit Document Feedback
ABSTRACT
Table of Contents
Explained......................................................................................................................................3
(TIOL112x)...................................................................................................................................4
Copyright © 2022 Texas Instruments Incorporated
Table of Contents
2
2
3
3
4
4
5
6
TIOx1x2x Evaluation Module
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Texas Instruments TIO 1 2 Series
Summary of Contents for Texas Instruments TIO 1 2 Series
-
Page 1: Table Of Contents
3 Schematic and Bill of Materials.............................5 3.1 Schematic..................................3.2 Bill of Materials...................................7 4 Revision History..................................9 Trademarks All trademarks are the property of their respective owners. SLLU344 – FEBRUARY 2022 TIOx1x2x Evaluation Module Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated... -
Page 2: Introduction
The profile of the board also allows it to be directly connected to a number of TI microcontroller boards for rapid prototyping. TIOx1x2x Evaluation Module SLLU344 – FEBRUARY 2022 Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated... -
Page 3: Evm Setup And Features Explained
500 mA to generate a wake-up request. Also, while in this mode, the device enables a small current sink of 5 mA (minimum) as required in the IO-Link standard specification, which calls for a minimum limit of 500 SLLU344 – FEBRUARY 2022 TIOx1x2x Evaluation Module Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated... -
Page 4: Fault Reporting (Nfault)
The external load to be driven by the switch can be connected to the wire terminal connector J1, M12 connector J2, or test points TP15 (CQ), TP11 (L+_24V), and TP12 (GND). TIOx1x2x Evaluation Module SLLU344 – FEBRUARY 2022 Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated... -
Page 5: Evm Jumper Settings
(nFAULT, DO_nFAULT, DO_EN, and DO_IN) 3 Schematic and Bill of Materials The EVM schematic and bill of materials can be referenced for circuit design or component questions. SLLU344 – FEBRUARY 2022 TIOx1x2x Evaluation Module Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated... -
Page 6: Schematic
SPI_MISO WAKE GPIO ! Analog_In/I2S_SCLK GPIO ! SPI_CS/GPIO ! I2C_SCL Analog_Out/I2S_SDout GPIO ! SPI_CS/GPIO ! DO_IN I2C_SDA Analog_Out/I2S_SDin GPIO ! GPIO ! SSQ-110-03-T-D SSQ-110-03-T-D TIOx1x2x Evaluation Module SLLU344 – FEBRUARY 2022 Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated... -
Page 7: Bill Of Materials
3269W-1-104LF Bourns Potentiometer Cermet 12 Turn Top Adjustment SH-J1, SH-J2, SH-J3, Shunt, 2.54mm, Gold, Black Shunt, 2.54mm, Black 60900213421 Wurth Elektronik SH-J4, SH-J5, SH-J6 SLLU344 – FEBRUARY 2022 TIOx1x2x Evaluation Module Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated... - Page 8 VSON10 D3, D4, D5, D6, D7 Diode, TVS, Bi, 30 V, 48.4 Vc, 400 W, 8.3 A, SMA (non- SMA (non-polarized) SMAJ30CA Littelfuse polarized) TIOx1x2x Evaluation Module SLLU344 – FEBRUARY 2022 Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated...
-
Page 9: Revision History
4 Revision History NOTE: Page numbers for previous revisions may differ from page numbers in the current version. DATE REVISION NOTES February 2022 Initial Release SLLU344 – FEBRUARY 2022 TIOx1x2x Evaluation Module Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated... - Page 10 STANDARD TERMS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, and/or documentation which may be provided together or separately (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms set forth herein.
- Page 11 www.ti.com Regulatory Notices: 3.1 United States 3.1.1 Notice applicable to EVMs not FCC-Approved: FCC NOTICE: This kit is designed to allow product developers to evaluate electronic components, circuitry, or software associated with the kit to determine whether to incorporate such items in a finished product and software developers to write software applications for use with the end product.
- Page 12 www.ti.com Concernant les EVMs avec antennes détachables Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à...
- Page 13 www.ti.com EVM Use Restrictions and Warnings: 4.1 EVMS ARE NOT FOR USE IN FUNCTIONAL SAFETY AND/OR SAFETY CRITICAL EVALUATIONS, INCLUDING BUT NOT LIMITED TO EVALUATIONS OF LIFE SUPPORT APPLICATIONS. 4.2 User must read and apply the user guide and other available documentation provided by TI regarding the EVM prior to handling or using the EVM, including without limitation any warning or restriction notices.
- Page 14 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2019, Texas Instruments Incorporated...
- Page 15 TI products. TI’s provision of these resources does not expand or otherwise alter TI’s applicable warranties or warranty disclaimers for TI products. TI objects to and rejects any additional or different terms you may have proposed. IMPORTANT NOTICE Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2022, Texas Instruments Incorporated...
- Page 16 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Texas Instruments TIOX1X2XEVM...
Need help?
Do you have a question about the TIO 1 2 Series and is the answer not in the manual?
Questions and answers