Working With Batteries - Matco Tools MBT1015 User Manual

- 7 -
MBT1015 rev-C
___________________________________________________________________________________
 Do not attach the analyser clips directly onto the steel bolt that tightened to the
battery terminal posts; this may give inaccurate readings or inconsistent
results. (Note: This also applies to all other battery testing methods.)
 If the battery terminal posts were oxidised or badly corroded and the
connections were bad, the analyser will prompt you to check the connections.
In this case, clean the terminal posts and performs testing directly on the
terminal posts it-self.
 During testing on the battery whist it is still in the car, make sure the engine is
OFF.
 Do not store the analyser near high humidity or temperature area. Exposing to
extreme temperatures will cause damage to the unit.

3.0 Working with Batteries

Lead-acid batteries contain a sulfuric acid electrolyte, which is a highly corrosive
poison and will produce gasses when recharged and explode if ignited. It can hurt you
badly.
When working with batteries, make sure you have plenty of ventilation, remove your
hand jewelry, watch and wear protective eyewear (safety glasses), clothing, and
exercise caution.
Do not allow battery electrolyte to mix with salt water. Even small quantities of this
combination will produce chlorine gas that can KILL you!
Whenever possible, please follow the manufacturer's instructions for testing, jumping,
installing, charging and equalising batteries.
 Never disconnect a battery cable from a vehicle with the engine running
because the battery acts like a filter for the electrical system.
User's Manual Versio18.08