Table of Contents
Advertisement
MBT1015 rev-C
4. Switch the ignition key to ON and start cranking the engine until it starts.
Immediately after that press
(Fig. 44):
Fig.44
5. If the voltage drop is too great during the cranking, the tested results will
display as follows (Fig.41) and will prompt you to check the starter system.
Fig.45
6. During cranking when it detects that there is no drop in voltage, it will display
the following screen (Fig.46).
Fig.46
key and the results will show as follows
Result: OK
Battery:
12.45V
Min. Volts: 10.56V
Volt Drop: Normal
[Exit] to Menu.
Result: High Drop
Battery:
12.45V
Min. Volts: 8.56V
Volt Drop: High
Check starter relay,
battery terminals or
battery has aged.
[Exit] to Menu.
Result: Not detected
Starter test failed!
No change in volts.
Check clamping at
battery side and test
again.
[Exit] to Menu.
User's Manual Version 18.08
-
30 -
Advertisement
Table of Contents
