Table of Contents
Advertisement
MBT1015 rev-C
The car engine and all other accessory loads must be OFF during test in order to
have accurate results. When attaching the analyser clips, make sure that the battery
posts were not oxidized or badly corroded. Clean them first before clamping to it. Do
not clamp onto the steel bolts directly which may give inaccurate and inconsistent
results.
Testing on stand-alone batteries
Clean the battery posts with a wire brush prior testing. For side post batteries, install
stud adaptors. Do not use steel bolts for better results.
1. Attach the Analyser clips onto the battery terminal posts [Red to (+) and Black
to (-)] the unit will power up and lights up the LCD display screen as shown
(Fig.16).
Fig.16
2. It will run through a self-test and when completed it displays the Main Menu as
shown: (Fig. 17)
Fig.17
Here, it will let you select your choice from the Menu:
Select Menu
23/12/2014
16.48
New: Test
Continue Test
Stored Results
Setup Menu
User's Manual Version 18.08
-
16 -
Advertisement
Table of Contents
