Key In Company Name And Contacts - Matco Tools MBT1015 User Manual

- 13 -
MBT1015 rev-C
___________________________________________________________________________________
Press or
next. Do this for the rest like month, year and the time. When the setting is done,
press key to save.

5.6 Key in Company name and contacts

This feature is for the user to key-in the company or garage name and the contact
information to be printed into the test report header. It allows 20 characters in one line
and accommodates up to seven lines maximum. To enter into this mode, power ON
the analyser by clamping into the battery terminals then on the Setup Menu go to the
Company name using
display as shown below (Fig.10).
1. Using the keys
to input.
2. To move one space backward of forward, use
need to correct any character or number that was previously keyed-in, use
these keys to move backwards and correct the entry using
3. Once confirmed, press
4. To clear at once all the characters being key in, press
5. When the key in had finished, press
press key to exit.
Note:
The information that has been keyed in will be shown in the result printout after
test
key to change the date and then press
or keys then after press
Company name
Fig.10
[Enter] to save
[Exit] to quit
or to scroll the numbers (0 to 9) or characters (A to Z)
key will move to the next line below.
User's Manual Versio18.08
key will enter into the
or keys. Also if there is a
or
key.
key to save the entry and then
to skip to the
keys.