Stretch Stitch Feed Balance - Horizon Fitness Memory Craft 9480 QC PROFESSIONAL Service Manual And Parts List

Stretch stitch feed balance

Adjust the stretch stitch balance dial at the setting mark.
The measurement of five of test patterns should be in the range of 33 to 39 mm as shown.
Reverse stitch button
Start/stop button
Incorrect
33 to 39 mm
Base lid C
Mechanical Adjustment
Stretch stitch
balance dial
Correct Incorrect
Direction Direction
of A of B
Adjusting screw D
To adjust:
1. Turn the power switch ON while pressing the start/
stop button and the reverse stitch button.
The LCD shows the factory setting mode.
Press the "8 Adjust" key.
2. Set the stretch stitch balance dial vertical.
3. Attach the satin stitch foot F.
Sew test patterns and measure the length of the 5
patterns.
The length should be 33 mm to 39mm.
4. If not, remove the base lid C.
Press the "Adjust" key so the adjusting screw D
comes to the adjusting position.
* Turn the adjusting screw in the direction of A if the
length is more than 39 mm.
* Turn the adjusting screw in the direction of B if the
length is less than 33 mm.
5. Sew the test pattern and measure the length of the
5 patterns.
6. Attach the base lid and turn the power switch OFF.
39