Thread Cutter - Horizon Fitness Memory Craft 9480 QC PROFESSIONAL Service Manual And Parts List

Thread cutter

The distance between the end of thread cutter plate slit and the end of moving cutter should be in the range
of 0.7 to 1.5 mm.
End of thread cutter plate slit
End of moving cutter
0.7 to 1.5 mm
A
B
Setscrew
Sensor plate
Mechanical Adjustment
To check:
1. Remove the bed cover and free arm cover (refer to
2. Turn the power switch ON.
3. The distance between the end of moving cutter and
Moving cutter
To adjust:
1. Turn the power switch OFF. Loosen the setscrew on
2. If the distance is smaller than 0.7 mm, move the
3. Turn the power switch ON to initialize the cutter
4. Attach the free arm cover and bed cover.
33
pages 3 to 5).
The moving cutter motor is initialized, and moving
cutter moves to its home position automatically.
the end of thread cutter plate slit should be 0.7 to
1.5 mm.
If not, adjust it as follows.
the sensor plate.
sensor plate in the direction of A.
If the distance is larger than 1.5 mm, move the sensor
plate in the direction of B.
position and check if the distance is within 0.7 to
1.5 mm.