Presser Bar Lifter Position - Horizon Fitness Memory Craft 9480 QC PROFESSIONAL Service Manual And Parts List

Presser bar lifter position

The clearance between the presser foot and the surface of the needle plate should be 6 mm when the
presser foot is raised. The presser foot (zigzag foot A) should be in parallel with the slot of the feed dog
teeth when attached.
Presser foot bar supporter
Needle plate
Slot
Should be
parallel
Zigzag foot (A)
Mechanical Adjustment
Hexagonal
socket screw
Zigzag foot (A)
6 mm
Spacer
To adjust:
1. Attach the zigzag foot (A).
Lower the feed dog.
2. Turn the power switch ON.
Press the presser foot lifter button to lower the
presser foot.
Turn the power switch OFF.
3. Raise the presser foot with the presser foot lifter.
* You must use the presser foot lifter to raise the
presser foot for this adjustment, otherwise you cannot
adjust the presser foot height correctly.
4. Open the face cover.
Place the 6 mm spacer (block) between the presser
foot and the needle plate.
Loosen the hexagonal socket screw on the presser
bar supporter (use an Allen wrench of 2 mm width
across flats).
5. Adjust the presser foot (A) direction as illustrated so
the slot for the feed dog teeth and the zigzag foot
should be parallel.
Tighten the hexagonal socket screw while depressing
the foot against the spacer.
34