Table of Contents
Advertisement
Preseer foot height on needle plate
Reverse stitch button
Start/stop button
Automatic presser foot lifter lever
Mechanical Adjustment
Presser foot
lifter stopper
Clearance
To adjust:
1. Turn the power switch ON while pressing the start/
stop button and the reverse stitch button.
The LCD shows the factory setting mode.
Press the "Foot Up/Down" key.
2. Attach the foot holder lightly (Do not tighten the
thumbscrew firmly.).
3. Press the "Down" key.
The presser bar will be lowered.
Tighten the thumbscrew firmly.
4. Press the "Init" key to initialize the settings.
Press the "Adjust" key to lower the foot.
There should be no gap between the foot and needle
plate, but no pressure applied to the needle plate.
Check it by tapping the toe of the foot with fingertip
as shown.
5. If there is a gap, press the "+" key to lower the foot
until the foot lands on the needle plate without the
gap.
6. If the foot depress the needle plate, press the "–" key
few times to raise the presser foot, then press the "+"
key to lower the foot until the foot lands on the needle
plate without the gap.
* Adjust the presser bar height always by pressing "+"
key.
Do not press the "–" at the end of this adjustment.
* The value of "Adjust Step" should be within the range
of 970 to 1030.
If the value is far out of the range, check automatic
presser foot lifter initializing position adjustment (refer
to page 37).
7. Turn the power switch ON again to enter the ordinary
sewing mode, and set the presser foot pressure to
"Auto-5".
Press the presser foot button to lower the presser
foot.
Be sure that there is a clearance between the presser
foot lifter stopper and the automatic presser foot lifter
lever as shown in the picture.
* If there is no clearance between the presser foot lifter
stopper and the automatic presser foot lifter lever,
adjust the presser bar height again.
38
Advertisement
Table of Contents
