Automatic Presser Foot Lifter Initializing Position - Horizon Fitness Memory Craft 9480 QC PROFESSIONAL Service Manual And Parts List

Automatic presser foot lifter initializing position

Adjust the foot sensor position when the presser foot lifter motor unit is replaced.
Reverse stitch button
Start/stop button
Adjusting screw
Mechanical Adjustment
To adjust:
1. Remove the top cover (refer to page 1).
2. Turn the power switch ON while pressing the start/
3. Turn the gear A (indicated with black arrow) with your
4. Place a 13 mm thick spacer between the presser foot
5. Be sure that the both "Sensor 1" and "Sensor 2"
Gear
6. Turn the adjusting screw counterclockwise until a
37
stop button and the reverse stitch button.
The LCD shows the factory setting mode.
Press the "Foot Sensor" key.
hand to raise the presser foot.
and the needle plate.
Lower the presser foot on the spacer firmly by turning
the gear.
show "H".
Press the "Start" key on the touch panel.
* In case either "Sensor 1" or "Sensor 2" is not "H",
turn the adjusting screw (indicated with white arrow)
clockwise until the both "Sensor 1" and "Sensor 2"
show "H".
beep sound and the "OK" message is shown.