Table of Contents
Advertisement
Buttonhole lever position
Reverse stitch button
Start/stop button
Buttonhole
lever guide
Setscrew
Buttonhole foot (R)
Mechanical Adjustment
Buttonhole
lever guide
⇔
Setscrew
Buttonhole lever
Hexagonal
socket screw
Hexagonal socket screw
1.6 mm
Stopper
Slider
1. Turn the power switch ON while pressing the start/
stop button and the reverse stitch button.
The LCD shows the factory setting mode.
Press the "BH Sensor" key.
2. Open the face cover.
Lower the buttonhole lever.
Loosen the setscrew on the buttonhole lever guide.
Move the buttonhole lever guide to the left to adjust
the position.
Tighten the setscrew when the indication below "BH
Sen" changes from "H" to "L".
3. Attach the automatic buttonhole foot (R).
Insert a 1.6 mm thick spacer between the stopper
and slider of the foot.
4. Press the presser foot lifter button to lower the
automatic buttonhole foot (R).
Lower the buttonhole lever.
5. Turn the hexagonal socket screw counterclockwise
(use an Allen wrench of 2 mm width across flats) until
the indication below "BH Sen" shows "H".
Turn the setscrew slowly clockwise until the indication
changes to "L".
32
Advertisement
Table of Contents
