Table of Contents
Advertisement
(5)
Obtain several lengths of flexible plastic or silicone tubing (3/8" ID x 1/16"
wall). Tubing IS NOT furnished with the unit and may be obtained from
laboratory supply dealers. Connect tubing from the rear of the housing to a
drain or sink for effluent. Connect tubing for the inlet from the rear of the
housing to a cold water source (<25
valve or faucet. Two pinch clamps have been provided. Check for leaks.
(6)
Keep power OFF. Insert the heater element into the Boiling Flask and press
the stopper into the Flask opening firmly. Heater should not be in contact
with any of the glass. NOTE: This must be sealed for distillation. Plug the
Heater into the Base Housing connector.
Product Service 1-800-522-7658
Chapter 2: Installation
o
C) with fine flow control through a
7
Advertisement
Table of Contents
Need help?
Do you have a question about the RapidStill I and is the answer not in the manual?