Table of Contents
Advertisement
Chapter 2: Installation
(2)
Starting with the large U-clamp, place both the large and small U-clamps
around the glassware and through the brackets. Gently tighten the clamp
nuts so that the glassware is firmly held to the Base Housing.
(3)
Carefully attach the condensing water tubing to the glass barb fittings. Do
not add clamps or any lubricant (other than water) to these connections.
Turn Base Housing upright.
(4)
Locate the RapidStill I where there is convenient 115 volt outlet and
accessibility to cold tap water and drain.
6
Product Service 1-800-522-7658
Advertisement
Table of Contents
Need help?
Do you have a question about the RapidStill I and is the answer not in the manual?